DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)
DSTIKE ESP32 Watch DevKit (Two versions)

DSTIKE ESP32 Watch DevKit (Two versions)

Regular price
$34.00
Sale price
$34.00
Shipping calculated at checkout.

I use DHL ecommerce shipped to

United States,Austria,Croatia,Czech Republic, Denmark, Finland, Germany, Hungary, Ireland Netherlands, Norway, Poland, Portugal, Slovenia, Spain, Switzerland, United Kingdom,Australia,Malaysia,Italy,Thailand ,Singapore,India

If you are out of these regions please visit my Aliexpress store and select AliExpress Standard Shipping

https://www.aliexpress.com/item/32956732012.html?spm=a2g1y.12024536.productList_110843472.pic_2

What is it?

It is a ESP32 Watch development board. There are two versions: OLED version and TFT color version. Both version share the same bottom board.

Why did you make it?

This product was planned at the same time of deauther wristband. I learned a lot of experience from deauther wristband and I knew ESP32 is a better choice for a "Watch".

The breakout pads are also designed to connect different sensors.

TX/RX could be used to communicate with computer or other control board.

17/16 is IIC port could be connected with RTC module or other IIC sensors.

SVP/SVN could input ADC signals.

25/26 could output DAC signals.

What makes it special?

  • Small size: 3.8x4.5cm
  • Height:1.5cm
  • Double 4 layer board
  • 600mAh battery inside
  • On/OFF Power Switch
  • OLED version:1.3OLED SH1106(SDA-17,SCL-16)
  • TFT color version: ST7789 240*240 LCD(SDA-17,SCL-16,DC-22,RES-23)
  • Buzzer-32
  • WS2812b RGB LED-33
  • Navigation Button(Up-19,Center-18,Down-5)
  • OLED version external slide button(22,23)
  • Highlight LED(27)
  • Indicate charging LED(On means Charging,OFF means Full)
  • Reset and Flash Button at Bottom board
  • Breakout GPIOs(TX,RX,17,16,SVP,SVN,25,26,GND,3V)

SD Card support

  • GPIO12--DAT2
  • GPIO13--DAT3
  • GPIO15--CMD
  • GPIO14--CLK
  • GPIO2--DAT0
  • GPIO4--DAT1
  • GPIO21--card

Tutorial:

1.Install the environment for ESP32

2.Install OLED library

Install TFT LCD library

3.Install Adafruit NeoPixel Library

4.Code Example for oled version

Code Example for TFT color version

Upload config